Windows

Opening/Closing Windows

The window opens while the switch is pressed and it closes while the switch is pulled up with the ignition switched ON. Do not open or close 3 or more windows at the same time.

The front passenger's window and rear windows can be opened/closed when the power window lock switch on the driver's door is in the unlocked position. Keep this switch in the locked position while children are in the vehicle.

 

Master control switches

  1. Close

  2. Open

  3. Driver's window

  4. Right rear window

  5. Power window lock switch

  6. Left rear window

  7. Front passenger's window

  8. Locked position

  9. Unlocked position

 

Front passenger's window switch/Rear window switches

  1. Close

  2. Open

 

 


  • A power window may no longer open/close if you continue to press the switch for a long time. If the power window does not open/close, wait for a while and then operate the switch again.

  • The passenger windows may be opened or closed using the master control switches on the driver's door.

  • The power window can be operated for about 40 seconds after the ignition is switched from ON to ACC or off with all doors closed. If any door is opened, the power window will stop operating.

Tilt/Slide Operation

The sunroof can be opened or closed electrically only when the ignition is switched ON.

  • Before leaving the vehicle or washing your Mazda, make sure the sunroof is completely closed so that water does not get inside the cabin area.

  • After washing your Mazda or after it rains, wipe the water off the sunroof before operating it to avoid water penetration which could cause rust and water damage to your headliner.

  1. Tilt/Slide switch

Tilt Operation

The rear of the sunroof can be tilted open to provide more ventilation.

 

To fully tilt automatically, momentarily press the tilt/slide switch.

To fully close automatically, momentarily press the tilt/slide switch in the forward direction.

To stop tilting partway, press the tilt/slide switch.

When the sunroof is already slid open and you want to tilt it open, first close the sunroof and then do a tilt operation.

  1. Tilt up

  2. Close (Tilt down)

 

Slide Operation

To fully open automatically, momentarily press the tilt/slide switch in the backward direction.

To fully close automatically, momentarily press the tilt/slide switch in the forward direction.

To stop sliding partway, press the tilt/slide switch.

When the sunroof is already tilted open and you want to slide it open, first close the sunroof and then do a slide operation.

  1. Open

  2. Close

 


If the sunroof does not operate normally, do the following procedure:

  1. Switch the ignition ON.

  2. Press the tilt switch, to partially tilt open the rear of the sunroof.

  3. Repeat Step 2. The rear of the sunroof tilts open to the fully open position, then closes a little.

 

If the reset procedure is performed while the sunroof is in the slide position (partially open) it will close before the rear tilt opens.

Jam-safe Sunroof

If a person's hands, head or an object blocks the sunroof while it is closing, the sunroof will stop and move in the open direction.

 


  • The jam-safe function may operate under the following conditions:

    • A strong impact is detected while the sunroof is closing automatically.

    • The sunroof is closing automatically during very low temperatures.

  • In the event the jam-safe function activates and the sunroof cannot be closed automatically, press the tilt/slide switch and the sunroof will close.

  • The jam-safe sunroof function does not operate until the system has been reset.

Page top