Drive Selection
Drive Selection (Some Models)
Drive Selection
Drive selection is a system to switch the vehicle's drive mode. When the sport mode is selected, vehicle's response against accelerator operation is enhanced. This provides additional quick acceleration which may be needed to safely make manoeuvres such as lane changes, merging onto freeways, or passing other vehicles.
Do not use the sport mode when driving on slippery roads such as wet or snow-covered roads. It may cause tyre slipping.
-
When the sport mode is selected, driving at higher engine speeds increases and it may increase fuel consumption. Mazda recommends that you cancel the sport mode on normal driving.
-
Drive mode cannot be switched in the following conditions:
-
ABS/TCS/DSC is operating
-
Cruise control is operating.
-
The Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop & Go function) System is operating.
-
Cruising & Traffic Support (CTS) (Some Models) is operating.
-
Steering wheel is being operated abruptly
-
Drive Selection Switch
Press the drive selection switch forward (SPORT) to select the sport mode.
Pull the drive selection switch back (OFF) to cancel the sport mode.
-
In the following cases, the drive selection is cancelled.
-
The ignition is switched OFF.
-
Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop & Go function) System/cruise control is set.
-
Cruising & Traffic Support (CTS) is set.
-
-
Depending on the driving conditions when sport mode is selected, the vehicle may perform shift-down or slightly accelerate.
Select Mode Indicator Light
When the sport mode is selected, the select mode indicator light turns on in the instrument cluster.
-
Select mode indicator light
If the drive selection cannot be switched to sport mode, the select mode indicator light flashes to notify the driver.
