If voice recognition learning has already been done.
Press the pick-up button or talk button with a short press.
Say: [Beep] “Voice training”
Prompt: “Enrolment is enabled/disabled. Would you like to disable/enable or retrain?”
Say: [Beep] “Retrain”
Prompt: “This operation must be performed in a quiet environment while the vehicle is stopped. See the owner's manual for the list of required training phrases. Press and release the talk button when you are ready to begin. Press the hang-up button to cancel at any time.”
Press the talk button with a short press.
The voice guidance reads out the voice input command number (refer to the voice input command list for voice recognition learning). (Ex. “Please read phrase 1”)
Say: [Beep] “0123456789” (Say the voice input command for voice recognition learning (1 to 8) according to the voice guidance.)
Prompt: “Speaker enrolment is complete.”
If an error occurred in the voice recognition learning, re-learning can be done by pressing the talk button with a short press.
Voice input command list for voice recognition learning
When reading out, the following points must be observed:
Read out the numbers one at a time correctly and naturally.
(For example, “1234” must be read out “one, two, three, four” not “twelve, thirty four”.)
Do not read out parentheses. “(” and hyphens “-” are used for separating numbers in a phone number.
Ex.
“(888) 555-1212” must be spoken “Eight, eight, eight, five, five, five, one, two, one, two.”
Phrase |
Command |
---|---|
1 |
0123456789 |
2 |
(888) 555-1212 |
3 |
Call |
4 |
Dial |
5 |
Setup |
6 |
Cancel |
7 |
Continue |
8 |
Help |
The applicable phrase appears in the audio display.
After user voice registration is completed, voice guidance “Speaker enrolment is complete” is announced.
Voice recognition learning on/off
Press the pick-up button or talk button with a short press.
Say: [Beep] “Voice training”
Prompt: “Enrolment is enabled/disabled. Would you like to disable/enable or retrain?”
Say: [Beep] “Disable” or “Enable”
When “Disable” is spoken, the voice recognition learning is turned off.
When “Enable” is spoken, the voice recognition learning is turned on.
Prompt: “Speaker Enrolment is disabled/enabled.”
Page top