Warning/Indicator Lights and Warning Sounds

Taking Action

Take the appropriate action and verify that the warning light turns off.

Signal

Warning

Action to be taken

(Amber)

Smart Brake Support/Smart City Brake Support (SBS/SCBS) Warning Light (Some Models)

The light turns on if the windscreen or the radar sensor are dirty, or there is a malfunction in the system.

Verify the reason why the warning light is illuminated on the centre display.

If the reason why the warning light is illuminated is due to a dirty windscreen, clean the windscreen.

If the warning light is illuminated because of a dirty radar sensor, clean the front emblem.

For any other reasons, have the vehicle inspected at an expert repairer, we recommend an Authorised Mazda Repairer.

Low Fuel Warning Indication/Warning Light

The light turns on when the remaining fuel is about 9.0 L (2.3 US gal, 1.9 Imp gal).

 


The light illumination timing may vary because fuel inside the fuel tank moves around according to the driving conditions and the vehicle posture.

Add fuel.

Seat Belt Warning Light (Front seat)

The seat belt warning light turns on if the driver or front passenger's seat is occupied and the seat belt is not fastened with the ignition switched ON.

If the driver or front passenger's seat belt is unfastened (only when the front passenger's seat is occupied) and the vehicle is driven at a speed faster than about 20 km/h (12 mph), the warning light flashes. After a short time, the warning light stops flashing, but remains illuminated. If a seat belt remains unfastened, the warning light flashes again for a given period of time.

 


  • If the driver or front passenger's seat belt is unfastened after the warning light turns on, and the vehicle speed exceeds 20 km/h (12 mph), the warning light flashes again.

  • To allow the front passenger occupant classification sensor to function properly, do not place and sit on an additional seat cushion on the front passenger's seat. The sensor may not function properly because the additional seat cushion could cause sensor interference.

  • If a small child is seated on the front passenger's seat, the warning light may not operate.

Fasten the seat belts.

(Red)

Seat Belt Warning Light (Rear seat)

If the rear seat belts are not fastened while the ignition is switched ON , the driver and the passenger are alerted by the warning light.

The warning light operates even if there is no passenger on the rear seat.

 


If a rear seat belt is not fastened by a certain period of time after the engine has been started, the warning light turns off.

Fasten the seat belts.

Door-Ajar/Liftgate-Ajar Warning Indication/Warning Light

The light turns on if any door/liftgate is not closed securely.

Close the door/liftgate securely.

 

KEY Warning Indication/Warning Light (Some Models)

Take the appropriate action and verify that the warning light turns off.

Signal

Cause

Action to be taken

(White)

KEY Warning Indication

The key battery is dead.

Replace the key battery (Search).

(Red)

(Flashing)

KEY Warning Light

The key battery is dead.

Replace the key battery (Search).

The key is not within the operation range.

Bring the key into the operation range (Search).

The key is placed in areas inside the cabin where it is difficult for the key to be detected.

A key from another manufacturer similar to the key is in the operation range.

Take the key from another manufacturer similar to the key out of the operation range.

Without the ignition switched off, the key is taken out of the cabin, and then all the doors are closed.

Bring the key back into the cabin.

Page top