Electric Parking Brake (EPB)
The EPB equipment applies the parking brake using an electric motor. When the parking brake is applied, the EPB switch indicator light turns on.
Do not drive the vehicle with the parking brake applied:
If the vehicle is driven with the parking brake applied, the brake parts may generate heat and the brake system may not operate, leading to an accident.
Before driving, release the parking brake and verify that the EPB indicator light is turned off.
-
The parking brake cannot be applied or released while the vehicle battery is dead.
-
If the EPB is repeatedly applied and released it may stop operating to prevent overheating of the motor. If this occurs, wait approx. 1 minute before operating the EPB switch again.
-
An operation sound occurs when applying or releasing the parking brake, however, this does not indicate a malfunction.
-
If the EPB is not used for long periods, an automatic inspection of the system is performed while the vehicle is parked. An operation sound can be heard, however, this does not indicate a problem.
-
When the parking brake is applied and the ignition is switched OFF, an operation sound can be heard, however, this does not indicate a problem.
-
The brake pedal may move while the parking brake is being applied or released, however, this does not indicate a problem.
-
If the EPB switch is continually pulled while driving the vehicle, the parking brake will be applied and the EPB warning beep will be activated. When the switch is released, the parking brake is released and the beep stops.
-
If the parking brake is applied with the ignition switched off or in ACC, the EPB indicator light in the instrument cluster and the indicator light in the switch may turn on for 15 seconds.
-
When running the vehicle through an automatic car wash, it may be necessary to switch the ignition off with the parking brake released depending on the type of automatic car wash.
When applying the parking brake
The parking brake can be applied regardless of the ignition switch position.
Securely depress the brake pedal and pull up the EPB switch.
The parking brake is applied and the EPB indicator light and the EPB switch indicator light turn on.
Refer to Warning/Indicator Lights (Search).
When releasing the parking brake
The EPB can be released while the ignition is switched ON or the engine is running. When the parking brake is released, the EPB indicator light and the EPB switch indicator light turn off.
Parking brake manual release
Firmly depress the brake pedal and press the EPB switch.
If the EPB switch is pressed without depressing the brake pedal, the display in the instrument cluster notifies the driver that the brake is not depressed.
(Type A instrument cluster)
A message is displayed on the multi-information display in the instrument cluster.
Refer to Message Indicated in Multi-information Display (Search).
(Type B instrument cluster)
The brake pedal operation demand indicator light (green) in the instrument cluster turns on.
Parking brake automatic release
If the accelerator pedal is depressed with the parking brake applied and all of the following conditions met, the parking brake is released automatically.
-
The engine is running.
-
The driver's door is closed.
-
The driver's seat belt is fastened.
(Manual transaxle)
-
The change lever is in a position other than neutral.
-
The clutch pedal is depressed halfway
(Automatic transaxle)
-
Selector lever is in the D, M, or R position
If something such as the driver's foot contacts the accelerator pedal with the engine running and the parking brake applied, the parking brake may be released automatically. If you do not intend to drive immediately, shift the change lever (manual transaxle) to the neutral position, or shift the selector lever (automatic transaxle) to the P or N position.
