Owner Maintenance

The interior lights have either LEDs or normal bulbs.

LED type

• Front overhead lights/Front map lights

• Centre map lights

• Rear overhead light

• Vanity mirror lights

• Luggage compartment light

The LED bulb cannot be replaced as a single unit because it is an integrated unit.

The LED bulb has to be replaced with the unit. We recommend an Authorised Mazda Repairer if the replacement is necessary.

Bulb type

Front overhead lighst/Front map lights, Centre map lights, Rear overhead light, Vanity mirror lights

1. Wrap a flathead screwdriver with a soft cloth to prevent damage to the lens, and then remove the lens by carefully prying on the edge of the lens with a flathead screwdriver.

2. Disconnect the bulb by pulling it out.

   Front overhead lights/Front map lights

   

   Centre map lights

   

   Rear overhead light

   

   Vanity mirror lights

   

3. Install the new bulb in the reverse order of the removal procedure.

Luggage compartment light

1. Wrap a small flathead screwdriver with a soft cloth to prevent damage to the lens and remove the lens unit by carefully prying on the edge of the lens unit with the flathead screwdriver.

   

2. Disconnect the electrical connector from the bulb by pressing the tab on the connector with your finger and pulling the connector.

   

    

   ---

   When replacing the bulb always disconnect the connector first. Otherwise, electric and electronic devices could be shorted.

   Close Caution

   View Caution

3. Insert the flathead screwdriver into the gap between the lens and the lens unit, and then slide the screwdriver to detach the lens.

   

4. Disconnect the bulb by pulling it out.

   

5. Install the new bulb in the reverse order of the removal procedure.