Child-Restraint System Suitability for Various Seat Positions Table
(Europe and countries conforming to the UN-R 16 regulation)
Provided information in the table shows your child-restraint system suitability for various seating position. For installation suitability of other manufacturer child-restraint system, carefully consult the manufacturer's instructions which accompany the child-restraint system.
When installing a child-restraint system, the following points must be observed:
-
(Front passenger seat/Second-row seat)
Always remove the head restraint before installing a child-restraint system. However, when installing a booster seat, always install the vehicle head restraint to the seat where the booster seat is installed. In addition, always use a tether strap and attach it securely. Refer to Head Restraints (Search).
-
When installing a child-restraint system to the front passenger seat, adjust the seat slide position as far back as possible. Adjust the seat bottom (height adjustable seat bottom) to the highest position so that the seat belt can securely fasten the child-restraint system.
Refer to Adjusting the Front Passenger's Seat (Search).
-
When it is difficult to install a child-restraint system to the front passenger seat/second-row seat, or the seat belt cannot be secured to the child-restraint system, perform the following operations to adjust the seat holding the child-restraint system so that the seat belt can be secured completely to it.
-
Move the seat forward.
-
Move the seatback forward or back.
-
(Second-row seat)
-
A child-restraint system with a support leg cannot be installed on the rear centre seat position.
-
When installing a child-restraint system came equipped with a tether, remove the head restraint.
Refer to Head Restraints (Search).
-
When installing a child-restraint system using the ISOFIX anchors, if the connectors of the child-restraint system do not reach the lower anchorage and the child-restraint system cannot be installed, slightly tilt the seatback of the seat holding the child-restraint system rearward. If the seatback of a second-row seat cannot be reclined due to interference with luggage on the rear seat or passengers, slide the seat forward once and then recline the seatback.
(Second-row seat/Third-row seat)
-
If the tether strap does not reach the anchor bracket, use an extension strap.
-
When installing a child-restraint system to the second-row seat or third-row seat, adjust the seat position of the front seat so that the child-restraint system does not contact the front seat.
Refer to Adjusting the Driver's Seat (Search).
Refer to Adjusting the Front Passenger's Seat (Search).
Refer to Seat Operation (Search).
-
When installing a child-restraint system to the rear seat, refer to the child-restraint system manufacturer's instructions and the Using ISOFIX Anchor (Search).
-
An i-Size child-restraint system refers to a child-restraint system which has acquired i-Size category certification for the UN-R 129 regulation.
Except Taiwan
|
Seating position |
Passenger |
Second-row seat (Left) |
Second-row seat (Centre) |
Second-row seat (Right) |
Third-row seat (Left) |
Third-row seat (Right) |
|---|---|---|---|---|---|---|
|
Seating position suitable for universal belted (Yes/No) |
No |
Yes (U) |
Yes (U) |
Yes (U) |
Yes (U) |
Yes (U) |
|
i-Size seating position (Yes/No) |
No |
No |
No |
No |
No |
No |
|
Largest suitable rearward facing fixture (R1) |
No |
Yes (IL) |
No |
Yes (IL) |
No |
No |
|
Largest suitable rearward facing fixture (R2) |
No |
Yes (IL) |
No |
Yes (IL) |
No |
No |
|
Largest suitable rearward facing fixture (R2X) |
No |
Yes (IL) |
No |
Yes (IL) |
No |
No |
|
Largest suitable rearward facing fixture (R3) |
No |
Yes (IL) |
No |
Yes (IL) |
No |
No |
|
Largest suitable forward facing fixture (F2) |
No |
Yes (IUF) |
No |
Yes (IUF) |
No |
No |
|
Largest suitable forward facing fixture (F2X) |
No |
Yes (IUF) |
No |
Yes (IUF) |
No |
No |
|
Largest suitable forward facing fixture (F3) |
No |
Yes (IUF) |
No |
Yes (IUF) |
No |
No |
|
Largest suitable lateral facing fixture (L1) |
No |
No |
No |
No |
No |
No |
|
Largest suitable lateral facing fixture (L2) |
No |
No |
No |
No |
No |
No |
|
Largest suitable booster fixture (B2) |
No |
Yes (IUF) |
No |
Yes (IUF) |
No |
No |
|
Largest suitable booster fixture (B3) |
No |
Yes (IUF) |
No |
Yes (IUF) |
No |
No |
|
Non i-size compatible with a support leg (Yes/No) |
Yes*1 |
Yes |
No |
Yes |
Yes |
Yes |
|
Lower ISOFIX anchorages but without Top Tether (Yes/No) |
No |
No |
No |
No |
No |
No |
U = Suitable for “universal” category restraints approved for use in this mass group.
UF = Suitable for forward-facing “universal” category restraints approved for use in this mass group.
IUF = Suitable for ISOFIX forward child restraints systems of universal category approved for use in the mass group.
L = Suitable for particular child restraints given on attached list. These restraints may be of the “specific vehicle”, “restricted” or “semi-universal” categories.
IL = Suitable for particular ISOFIX child restraint systems (CRS) given in the attached list. These ISOFIX CRS are those of the “specific vehicle”, “restricted” or “semi-universal” categories.
i-U = Suitable for i-Size “universal” Child Restraint Systems forward and rearward facing.
i-UF = Suitable for forward-facing i-Size “universal” Child Restraint Systems only.
Yes = Child-restraint system can be secured on the seat.
No = Child-restraint system cannot be secured on the seat, or there is no fixture.
X = Child-restraint system cannot be installed.
-
Child restraint system can only be installed in the forward-facing position.
A Mazda genuine child-restraint system can be installed. Regarding child-restraint systems which can be installed, refer to the accessories catalog.
Taiwan
ISOFIX anchor-secured child-restraint systems
|
Mass group |
Size Class |
Fixture |
Vehicle ISOFIX positions |
|---|---|---|---|
|
Second-row seat (Outboard) |
|||
|
Carrycot |
F |
ISO/L1 |
X |
|
G |
ISO/L2 |
X |
|
|
(1) |
X |
||
|
GROUP 0 Up to 10 kg (up to 22 lb) |
E |
ISO/R1 |
IL |
|
(1) |
X |
||
|
GROUP 0 Up to 13 kg (up to 29 lb) |
E |
ISO/R1 |
IL |
|
D |
ISO/R2 |
IL |
|
|
C |
ISO/R3 |
IL |
|
|
(1) |
X |
||
|
GROUP 1 9 kg ― 18 kg (20 lb ― 40 lb) |
D |
ISO/R2 |
IL |
|
C |
ISO/R3 |
IL |
|
|
B |
ISO/F2 |
IUF |
|
|
B1 |
ISO/F2X |
IUF |
|
|
A |
ISO/F3 |
IUF |
|
|
(1) |
X |
||
|
GROUP 2 15 kg ― 25 kg (33 lb ― 55 lb) |
(1) |
X |
|
|
GROUP 3 22 kg ― 36 kg (48 lb ― 79 lb) |
(1) |
X |
|
(1) For the CRS which do not carry the ISO/XX size class identification (A to G), for the applicable mass group, the car manufacturer shall indicate the vehicle specific ISOFIX child-restraint system(s) recommended for each position.
Key of letters to be inserted in the above table:
IUF = suitable for ISOFIX forward child-restraints systems of universal category approved for use in this mass group.
IL = suitable for particular ISOFIX child-restraint systems (CRS).
These ISOFIX CRS are those of the “specific vehicle”, “restricted” or “semi-universal” categories.
X = ISOFIX position not suitable for ISOFIX child-restraint systems in this mass group and/or this size class.
i-Size child-restraint systems
An i-Size child-restraint system can be installed to the specified seat as follows:
|
Front passenger seat |
Rear seat (outboard) |
Rear seat (centre) |
|
|---|---|---|---|
|
i-Size child-restraint systems |
X |
X |
X |
Key of letters to be inserted in the above table:
X = Seating position not suitable for i-Size “universal” child-restraint systems.
Seat belt-secured child-restraint systems
|
System group |
Age group |
Weight group |
Child-restraint system type |
Front passenger seat |
Second-row seat (outboard) |
Second-row seat (centre) |
Third-row seat (outboard) |
|---|---|---|---|---|---|---|---|
|
GROUP 0 |
Up to about 9 months old |
Up to 10 kg (up to 22 lb) |
Baby seat |
X |
U |
U*2 |
U |
|
GROUP 0 |
Up to about 2 years old |
Up to 13 kg (up to 29 lb) |
Baby seat |
X |
U |
U*2 |
U |
|
GROUP 1 |
About 8 months to 4 years old |
9 kg ― 18 kg (20 lb ― 40 lb) |
Child seat |
L*1 |
U |
U*2 |
U |
|
GROUP 2 |
About 3 to 7 years old |
15 kg ― 25 kg (33 lb ― 55 lb) |
Junior seat |
L*1 |
U |
U*2 |
U |
|
GROUP 3 |
About 6 to 12 years old |
22 kg ― 36 kg (48 lb ― 79 lb) |
Junior seat |
L*1 |
U |
U*2 |
U |
Key of letters to be inserted in the above table:
U = Suitable for “universal” category restraints approved for use in this mass group.
L = For the child restraint systems categorized in this weight group, consult an Authorised Mazda Dealer. Regarding child restraint systems which can be installed, refer to the accessories catalog.
X = Seat position not suitable for children in this mass group.
-
A Mazda genuine child restraint system can be installed in the forward-facing position.
-
When a child-restraint system is installed to the rear centre seat, do not seat occupants in the rear left outboard seat position.
(Other countries)
-
Regarding child-restraint systems which can be installed to your Mazda, consult an Authorised Mazda Dealer.
-
A child-restraint system with a support leg cannot be installed on the rear centre seat position.
-
Please comply with the legal regulations concerning the use of child-restraint systems in your country.
