Owner Maintenance

Light Bulbs

Light Bulbs

Headlights (Low/High beam)

Headlights (High beam)

Running lights/Position lights/Front direction indicator lights

Position lights

Running lights

Front fog lights (Some Models)

Front direction indicator lights

Side direction indicator lights

Brake lights/Tail lights

Rear direction indicator lights

Tail lights

Reverse lights

Brake lights

Rear fog light (Left-hand drive model) (Some Models)

Rear fog light (Right-hand drive model) (Some Models)

High-mount brake light

Number plate lights

Overhead lights (Front)/Map lights (Front)

Map lights (Centre)

Overhead light (Rear)

Vanity mirror lights

Ambient lights (Front/Rear door pocket)

Luggage compartment light

 

When removing the lens or lamp unit using a flathead screwdriver, make sure that the flathead screwdriver does not contact the interior terminal. If the flathead screwdriver contacts the terminal, a short circuit may occur.

Close Caution
View Caution

 

  • To replace the bulb, contact an expert repairer (we recommend an Authorised Mazda Repairer).

  • Use the protective cover and carton for the replacement bulb to dispose of the old bulb promptly and out of the reach of children.

Close Note
View Note

Replacing Interior Light Bulbs

Overhead lights (Front)/Map lights (Front) (LED type), Overhead lights (Centre)/Map lights (Centre) (LED type), Overhead lights (Rear) (LED type), Vanity mirror lights (LED type), Ambient lights

The LED bulb cannot be replaced as a single unit because it is an integrated unit.

The LED bulb has to be replaced with the unit. We recommend an Authorised Mazda Repairer when the replacement is necessary.

Overhead lights (Front)/Map lights (Front) (bulb type), Overhead lights (Centre)/Map lights (Centre) (bulb type), Overhead light (Rear) (bulb type), Vanity mirror lights (bulb type)

  1. Wrap a small flathead screwdriver with a soft cloth to prevent damage to the lens, and then remove the lens by carefully prying on the edge of the lens with the flathead screwdriver.

  2. Disconnect the bulb by pulling it out.

    Overhead lights (Front)/Map lights (Front)

     

     

    Overhead lights (Centre)/Map lights (Centre)

     

     

    Overhead light (Rear)

     

    Vanity mirror lights

     

  3. Install the new bulb in the reverse order of the removal procedure.

Luggage compartment light

(LED type)

The LED bulb cannot be replaced as a single unit because it is an integrated unit.

The LED bulb has to be replaced with the unit. We recommend an Authorised Mazda Repairer when the replacement is necessary.

(Bulb type)

  1. Wrap a small flathead screwdriver with a soft cloth to prevent damage to the lens and remove the lens unit by carefully prying on the edge of the lens unit with the flathead screwdriver.

     

  2. Disconnect the electrical connector from the bulb by pressing the tab on the connector with your finger and pulling the connector.

     

     

    When replacing the bulb always disconnect the connector first. Otherwise, electric and electronic devices could be shorted.

    Close Caution
    View Caution

  3. Insert the flathead screwdriver into the gap between the lens and the lens unit, and then slide the screwdriver to detach the lens.

     

  4. Disconnect the bulb by pulling it out.

     

  5. Install the new bulb in the reverse order of the removal procedure.

Page top