Spare Tyre and Tool Storage
Changing a Flat Tyre

Changing a Flat Tyre

 


If the following occurs while driving, it could indicate a flat tyre.

  • Steering becomes difficult.

  • The vehicle begins to vibrate excessively.

  • The vehicle pulls in one direction.

Close Note
View Note

If you have a flat tyre, drive slowly to a level spot that is well off the road and out of the way of traffic to change the tyre.

Stopping in traffic or on the shoulder of a busy road is dangerous.

 


Be sure to follow the directions for changing a tyre:

Changing a tyre is dangerous if not done properly. The vehicle can slip off the jack and seriously injure someone.

No person should place any portion of their body under a vehicle that is supported by a jack.

Never allow anyone inside a vehicle supported by a jack:

Allowing someone to remain in a vehicle supported by a jack is dangerous. The occupant could cause the vehicle to fall resulting in serious injury.

Close Warning
View Warning

 


Make sure the jack is well lubricated before using it.

Close Note
View Note
  1. Park on a hard, level surface off the right-of-way and firmly set the parking brake.

  2. Put a vehicle with an automatic transaxle in Park (P), a manual transaxle in Reverse (R) or 1, and turn off the engine.

  3. Turn on the hazard warning flasher.

  4. Have everyone get out of the vehicle and away from the vehicle and traffic.

  5. Remove the jack, tool, and spare tyre (Search).

  6. Block the wheel diagonally opposite the flat tyre. When blocking a wheel, place a tyre block both in front and behind the tyre.

     


    When blocking a tyre, use rocks or wood blocks of sufficient size if possible to hold the tyre in place.

    Close Note
    View Note