Running-In
Saving Fuel and Protection of the Environment
Hazardous Driving
Floor Mat
Rocking the Vehicle
Winter Driving
Driving In Flooded Area
Turbocharger Information (SKYACTIV-D 1.5)
Before DrivingDriving TipsWinter Driving

Tyre Chains

Check local regulations before using tyre chains.

 

  • Chains may affect handling.

  • Do not go faster than 50 km/h (30 mph) or the chain manufacturer's recommended limit, whichever is lower.

  • Drive carefully and avoid bumps, holes, and sharp turns.

  • Avoid locked-wheel braking.

  • Do not use chains on a temporary spare tyre; it may result in damage to the vehicle and to the tyre.

    In some models, the vehicle is not equipped with a factory installed temporary spare tyre.

  • Do not use chains on roads that are free of snow or ice. The tyres and chains could be damaged.

  • Chains may scratch or chip aluminium wheels.

Close Caution
View Caution

 

  • If your vehicle is equipped with the tyre pressure monitoring system, the system may not function correctly when using tyre chains.

  • Use of tyre chains on a vehicle equipped with 185/60R16 tyres could cause interference with the vehicle body and scratching. If tyre chains are to be used, replace both the front and rear tyres with 185/65R15 tyres and replace both the front and rear wheels with genuine Mazda 15-inch wheels of the same size, and use genuine Mazda tyre chains. Consult an expert repairer, we recommend an Authorised Mazda Repairer.

Close Note
View Note

Install the chains on the front tyres only.

Do not use chains on the rear tyres.

Tyre chain selection (Europe)

Mazda recommends hexagon type steel ring chains. Select the proper type according to your tyre size.

 

Tyre size

Tyre chain

185/65R15

Hexagon type

 

Although Mazda recommends hexagon type steel ring chains, all chains within the installation specifications may be used.

Close Note
View Note

Installation specification (Europe)

When installing tyre chains, the distance between the tyre tread and the chain must be within the prescribed limits in the following table.

Distance [Unit: mm (in)]

A

B

MAX 11 (0.43)

MAX 11 (0.43)

 

Installing the chains

  1. If your vehicle is equipped with wheel covers remove them, otherwise the chain bands will scratch them.

  2. Secure the chains on the front tyres as tightly as possible. Always follow the chain manufacturer's instructions.

  3. Retighten the chains after driving 1/2―1 km (1/4―1/2 mile).