When you need a sunvisor, lower it for use in front or swing it to the side.
To use the vanity mirror, lower the sunvisor.
If your vehicle is equipped with a vanity mirror light, it will illuminate when you open the cover.
To prevent the battery from being discharged, the vanity mirror will only illuminate in the tilt range shown in the figure.
Do not leave the lights on for long periods while the engine is turned off. Otherwise, the battery power could be depleted.
Overhead Lights
Switch Position |
Overhead Lights |
---|---|
![]() |
Light off |
![]() |
|
![]() |
Light on |
The rear overhead light also turn on and off when the front overhead light switch is operated.
Map Lights
When the overhead light switch is in the door or off position, press the lens to illuminate the map lights, and then press the lens again to turn them off.
The map lights will not turn off even if the lens is pressed in the following cases:
The overhead light switch is in the ON position.
The overhead light switch is in the door position with the door open.
The illuminated entry system is on.
Luggage Compartment Lights (Hatchback)
Switch Position |
Luggage Compartment Light |
---|---|
![]() |
Light off |
![]() |
Light on when the liftgate is open |
Boot Light (Saloon)
The boot light is on when the lid is open and off when it's closed.
To prevent the battery from being discharged, do not leave the boot open for a long period when the engine is not running.
When the illuminated entry system operates, the overhead lights turn on in the following conditions:
The driver's door is unlocked after the ignition is switched OFF.
The ignition is switched OFF with all doors closed.
The illuminated entry system operates when the overhead light switch is in the DOOR position.
The illumination time differs depending on the operation.
Battery saver
If an interior light is left on with the ignition switched OFF, the light is turned off automatically after about 30 minutes to prevent battery depletion.
The operation of the illuminated entry system can be changed.
Refer to Personalisation Features (Search).
Only use genuine Mazda accessories or the equivalent requiring no greater than 120 W (DC 12 V, 10 A).
The ignition must be switched to ACC or ON.
Type A
Type B
To prevent accessory socket damage or electrical failure, pay attention to the following:
Do not use accessories that require more than 120 W (DC 12 V, 10 A).
Do not use accessories that are not genuine Mazda accessories or the equivalent.
Close the cover when the accessory socket is not in use to prevent foreign objects and liquids from getting into the accessory socket.
Correctly insert the plug into the accessory socket.
Do not insert the cigarette lighter into the accessory socket.
Noise may occur on the audio playback depending on the device connected to the accessory socket.
Depending on the device connected to the accessory socket, the vehicle's electrical system may be affected, which could cause the warning light to illuminate. Disconnect the connected device and make sure that the problem is resolved. If the problem is resolved, disconnect the device from the socket and switch the ignition off. If the problem is not resolved, consult an expert repairer, we recommend an Authorised Mazda Repairer.
To prevent discharging of the battery, do not use the socket for long periods with the engine off or idling.
Connecting the accessory socket
Open the lid.
Pass the connection plug cord through the cutout of the console and insert the plug into the accessory socket.
Never use a cup holder to hold hot liquids while the vehicle is moving:
Using a cup holder to hold hot liquids while the vehicle is moving is dangerous. If the contents spill, you could be scalded.
Do not put anything other than cups or drink cans in cup holders:
Putting objects other than cups or drink cans in a cup holder is dangerous.
During sudden braking or manoeuvring, occupants could be hit and injured, or objects could be thrown around the vehicle, causing interference with the driver and the possibility of an accident. Only use a cup holder for cups or drink cans.
Bottle holders are on the inside of the doors.
Front
Rear
Do not use the bottle holders for containers without caps. The contents may spill when the door is opened or closed.