Seat Warmer/Heated Steering Wheel
Seat Belt Systems
Seat Belt Warning Systems
Seat Belt Pretensioner and Load Limiting Systems
Child-Restraint System Installation
Advanced Keyless Entry System
Doors and Locks
Fuel and Emission
Mirrors
Windows
Security System
Driving Tips
Saving Fuel and Protection of the Environment
Hazardous Driving
Floor Mat
Rocking the Vehicle
Winter Driving
Driving In Flooded Area
Starting the Engine
i-stop
Manual Transmission Operation
Automatic Transmission
Shift-Lock System
Transmission Ranges
Manual Shift Mode
Driving Tips
Rear Window Wiper and Washer (Some Models)
Horn
Hazard Warning Flasher
ABS/TCS/DSC
Drive Selection
Power Steering
i-ACTIVSENSE
Driver Attention Alert (DAA)
Front Radar Sensor
Front Side Radar Sensor (Some Models)
Rear Side Radar Sensor
Rear/Rear corner/Rear Side Ultrasonic Sensor (Some Models)
Driver Monitoring Camera (Some Models)
Tyre Pressure Monitoring System
Rear View Monitor
Parking Sensor System
MZD Connect
Interior Equipment
Scheduled Maintenance
Owner Maintenance
Bonnet
Engine Compartment Overview
Engine Oil
Engine Coolant
Brake/Clutch Fluid
Window Washer Fluid
Body Lubrication
Wiper Blades
Tyres
Fuses
Emission Control Maintenance (Australia)
Flat Tyre
Battery Runs Out
Emergency Starting
Overheating
Emergency Towing
Warning/Indicator Lights and Warning Sounds
Warning Sound is Activated
Active Driving Display Does Not Operate
Windscreen Wipers Operate at High Speed
Cell Phones
Recording of Vehicle Data
Declaration of Conformity
Press the 
switch.
Set the temperature control dial to the cold position.
Set the fan control dial to the desired speed.
Turn on the air conditioner by pressing the A/C switch.
After cooling begins, adjust the fan control dial and temperature control dial as needed to maintain maximum comfort.
If the air conditioner is used while driving up long hills or in heavy traffic, monitor the high engine coolant temperature warning indication to see if it is displayed (Search).
The air conditioner may cause engine overheating. If the warning indication is displayed, turn the air conditioner off (Search).
When maximum cooling is desired, set the temperature control dial to the extreme cold position and set the air intake selector to the recirculated air position, then turn the fan control dial fully clockwise.
If warmer air is desired at floor level, press the 
switch and adjust the temperature control dial to maintain maximum comfort.
The air to the floor is warmer than air to the face (except when the temperature control dial is set at the extreme hot or cold position).
Page top
