Setting the System

 

Always verify the safety of the surrounding area when setting the ISA:

If the speed is set lower than the current vehicle speed, the vehicle speed is decreased to the set speed. Verify the safety of the surrounding area and keep a safer distance between vehicles ahead and behind you.

Close Warning
View Warning

 

  • The system is temporarily cancelled when the vehicle is accelerated by depressing the accelerator pedal strongly, however, it resumes when the vehicle speed decreases to the set speed or less.

  • The vehicle speed may exceed the set speed on a down slope.

  • In the following cases, the system cannot be set.

    • Any door is open.

    • The driver's seat belt is unfastened.

  • The ISA setting can be changed to MANUAL, or OFF*1.

    Refer to the Settings section in the MZD Connect Owner's Manual.

  1. When OFF is selected, the Adjustable Speed Limiter (ASL) is set.

Refer to Adjustable Speed Limiter (ASL) (Search)

Close Note
View Note

How to set the speed limit using the SET switch

  1. Press the LIM switch to turn the system on.

  2. Press the RES switch up (SET+) or down (SET-) to set the speed. When the current vehicle speed is 30 km/h (19 mph) or more, the speed is set to the current vehicle speed. When the current vehicle speed is less than 30 km/h (19 mph), the speed is set to 30 km/h (19 mph).

  3. To increase the set speed, press the RES switch up (SET+) continuously. The set speed can be adjusted in 10 km/h (5 mph) increments. The set speed can also be adjusted in about 1 km/h (1 mph) increments by pressing the RES switch up (SET+) momentary. For example, the set speed increases about 4 km/h (4 mph) by pressing the RES switch up (SET+) switch 4 times.

  4. To decrease the set speed, press the RES switch down (SET-) continuously. The set speed can be adjusted in 10 km/h (5 mph) increments. The set speed can also be adjusted in about 1 km/h (1 mph) increments by pressing the RES switch down (SET-) momentary. For example, the set speed decreases about 4 km/h (4 mph) by pressing the RES switch down (SET-) 4 times.

 

  • When the vehicle set speed is displayed in the active driving display/instrument cluster and speed limit sign is not displayed, press the RES switch to set the displayed vehicle speed.

Close Note
View Note

Manually setting the vehicle speed limit from a speed limit sign

  1. Press the LIM switch to turn the system on.

  2. Press the RES switch while the ISA set indication is displayed on the active driving display/instrument cluster to set the vehicle speed limit to the speed of the displayed speed limit sign.

  1. Speed limit sign setting indication

 

  • The speed limit cannot be set from the speed limit sign when the speed limit sign indication is displayed in gray.

Close Note
View Note

Excessive speed range setting

The range of speed that can exceed the set speed can be changed.

Refer to the Settings section in the MZD Connect Owner's Manual.

  • + 0: The vehicle speed is restricted at the set speed.

  • + 5: If the vehicle speed exceeds the set speed by 5 km/h (3mph), the vehicle speed is restricted.

  • + 10: If the vehicle speed exceeds the set speed by 10 km/h (5 mph), the vehicle speed is restricted.

Page top