Warning/Indicator Lights and Warning Sounds

If the ignition is switched OFF with the exterior lights turned on and the driver’s door is opened, a sound is activated.

Operate the headlight switch to turn off the exterior lights.

 

---

• When the ignition is switched to ACC, the “Ignition Not Switched OFF (STOP) Warning Beep” (Search) overrides the lights-on reminder.

• A personalised function is available to change the sound volume for the lights-on reminder.

  Refer to the Settings section in the Mazda Connect Owner's Manual.

Close Note

View Note

Front seat

If the vehicle speed exceeds about 20 km/h (12 mph) with the driver or front passenger's seat belt unfastened, a warning beep sounds continuously. If the seat belt remains unfastened, the beep sound stops once and then continues for about 90 seconds. The beep stops after the driver or front passenger's seat belt is fastened.

 

---

• Placing heavy items on the front passenger seat may cause the front passenger seat belt warning function to operate depending on the weight of the item.

• To allow the front passenger seat weight sensor to function properly, do not place and sit on an additional seat cushion on the front passenger seat. The sensor may not function properly because the additional seat cushion could cause sensor interference.

• When a small child sits on the front passenger seat, it is possible that the warning beep will not operate.

Close Note

View Note

Rear seat

The warning beep only sounds if a seat belt is unfastened after being fastened.

European models

If the driver's door is opened with the ignition switched to ACC, a beep will be heard 6 times in the cabin to notify the driver that the ignition has not been switched OFF (STOP). Under this condition, the keyless entry system will not operate, the vehicle cannot be locked, and the battery voltage will be depleted.

Except European models

If the driver's door is opened with the ignition switched to ACC, a beep will be heard continuously in the cabin to notify the driver that the ignition has not been switched OFF (STOP). Under this condition, the keyless entry system will not operate, the vehicle cannot be locked, and the battery voltage will be depleted.

Vehicles with advanced keyless function

If the key is taken out of the vehicle while the ignition is switched to ACC or ON, and all the doors are closed, a sound is activated 6 times outside of the vehicle and a sound is activated 1 time in the vehicle.

Vehicles without advanced keyless function

If the key is taken out of the vehicle while the ignition is switched to ACC or ON, and all the doors are closed, a sound is activated 1 time in the vehicle.

 

---

Make sure that you leave the vehicle while carrying the key, or switch the ignition OFF.

Close Note

View Note

A warning beep is activated to notify the driver that the doors are not locked when all of the following conditions are met:

• The ignition is switched OFF.

• All the doors and liftgate are not fully closed.

• The lock is operated 3 times within 5 seconds.

Check the ignition and whether the doors and liftgate are open or closed, and then operate the lock again.

When the door-lock switch on the liftgate is pressed under any of the following conditions, a warning sound is activated.

• The ignition is switched to a position other than OFF.

• Any door is open.

Make sure that none of the above conditions are present, and then press the door-lock switch again.

If the key is left in the luggage compartment/boot with all the doors locked and the liftgate/boot lid closed, a beep will be heard outside for about 10 seconds to notify the driver that the key is in the luggage compartment/boot. In this case, take out the key by pressing the electric liftgate/boot lid opener and opening the liftgate/boot lid. The key taken out of the luggage compartment/boot may not operate because its functions have been temporarily stopped. To restore the key's functions, perform the applicable procedure (Search).

If all the doors and luggage compartment/boot are locked using another key while the key is left in the cabin, the beep which sounds outside of the vehicle will be heard for about 10 seconds to notify the driver that the key is in the cabin. In this case, take out the key by opening the door. A key taken out of the vehicle using this method may not operate because its functions have been temporarily stopped. To restore the key's functions, perform the applicable procedure (Search).

When the low fuel warning light flashes, a warning beep is activated once at the same time.

The warning beep operates if the steering wheel is not unlocked after the push button start is pressed. (Search)

A warning beep is activated when the accelerator pedal and brake pedal are depressed at the same time while driving. Only depress the brake pedal.

If any of the following problems occur, a warning beep is activated. Check the information regarding the warning indication in the instrument cluster or on the centre display.

• Automatic transmission problem

• Increase in automatic transmission internal temperature

• M Hybrid problem

• Brake fluid amount decrease

• Engine oil level sensor problem

• Electric Parking Brake (EPB) problem

• Engine hydraulic pressure decrease

• Engine coolant temperature increase

• Engine system problem

A sound is activated when the push button start is pressed while the selector lever is in a position other than P, and the ignition is switched to ACC. Check the selector lever position.

A warning beep is activated continuously if the driver's door is opened with the selector lever in a position other than the P or N position when the engine is running. Shift the selector lever to the P or N position, or close the driver's door.

• If the driver's door is opened while engine idling is stopped, the warning sound operates to notify the driver that engine idling is stopped. It stops when the driver's door is closed.

• The warning sound operates if the following operations are performed while the engine idling is stopped. In such cases, the engine does not restart automatically to ensure safety. Start the engine using the normal method.

  (With M Hybrid)

  • (Manual transmission)

    With the shift lever in a position other than neutral, the driver's door is opened.

  • (Automatic transmission)

    With the selector lever in the D or M (not in second gear fixed mode) position, the driver's seat belt is unfastened and the driver's door is opened.

  (Without M Hybrid)

  • (Manual transmission)

    With the shift lever in a position other than neutral, the driver's seat belt is unfastened and the driver's door is opened.

  • (Automatic transmission)

    With the selector lever in the D or M (not in second gear fixed mode) position, the driver's seat belt is unfastened and the driver's door is opened.

The warning buzzer is activated under the following conditions:

• The vehicle is driven with the parking brake applied.

• The Electric Parking Brake (EPB) switch is pulled while the vehicle is driven.

• You attempt to start driving the vehicle while the conditions for releasing the Electric Parking Brake (EPB) automatically have not been met.

Message is displayed and beep sound is activated simultaneously for about 5 seconds when using AUTOHOLD function or when AUTOHOLD switch is operated.

Because a problem with AUTOHOLD function has occurred, AUTOHOLD function does not operate even if AUTOHOLD switch is operated.

If the message is displayed and the beep sound is activated simultaneously, have your vehicle inspected at an expert repairer (we recommend an Authorised Mazda Repairer).

Warns the driver of the possibility of icy roads when the outside temperature is low.

If the outside temperature is lower than about 4 °C (39 °F) , a beep sound is heard once and the outside temperature display flashes for about 10 seconds.

Refer to Outside Temperature Display (Search).