Read this first
Dynamic Stability Control (DSC)
The Dynamic Stability Control (DSC) automatically controls braking and engine torque in conjunction with systems such as ABS and TCS to help control side slip when driving on slippery surfaces, or during sudden or evasive manoeuvring, enhancing vehicle safety.
Refer to ABS (Search) and TCS (Search).
DSC operation is possible at speeds greater than 20 km/h (12 mph).
A system malfunction or operation conditions are indicated by a warning.
Refer to Warning/Indicator Lights (Search).
Do not rely on the Dynamic Stability Control as a substitute for safe driving:
The Dynamic Stability Control (DSC) cannot compensate for unsafe and reckless driving, excessive speed, tailgating (following another vehicle too closely), and hydroplaning (reduced tyre friction and road contact because of water on the road surface). You can still have an accident.
-
The DSC may not operate correctly unless the following are observed:
-
Use tyres of the correct size specified for your Mazda on all four wheels.
-
Use tyres of the same manufacturer, brand and tread pattern on all four wheels.
-
Do not mix worn tyres.
-
-
The DSC may not operate correctly when tyre chains are used or a temporary spare tyre is installed because the tyre diameter changes.
DSC OFF Switch
Press the DSC OFF switch to turn off the TCS/DSC. The DSC OFF indicator light in the instrument cluster will illuminate.
Press the switch again to turn the TCS/DSC back on. The DSC OFF indicator light will turn off.
-
When DSC is on and you attempt to free the vehicle when it is stuck, or drive it out of freshly fallen snow, the TCS (part of the DSC system) will activate. Depressing the accelerator will not increase engine power and freeing the vehicle may be difficult. When this happens, turn off the TCS/DSC.
-
If the TCS/DSC is off when the engine is turned off, it automatically activates when the ignition is switched ON.
-
Leaving the TCS/DSC on will provide the best traction.
-
If the DSC OFF switch is pressed and held for 10 seconds or more, the DSC OFF switch malfunction detection function operates and the DSC system activates automatically. The DSC OFF indicator light turns off while the DSC system is operative.
