Replacing Interior Light Bulbs

Overhead lights/Front map lights (LED type), Rear map lights (LED type), Vanity mirror lights (LED type) (Some Models), Courtesy lights, Ambient lights (Some Models)

The LED bulb cannot be replaced as a single unit because it is an integrated unit.

The LED bulb has to be replaced with the unit. We recommend an Authorised Mazda Repairer when the replacement is necessary.

Overhead lights/Front map lights (Bulb type), Rear map lights (Bulb type), Vanity mirror lights (Bulb type) (Some Models)

  1. Wrap a small flathead screwdriver with a soft cloth to prevent damage to the lens, and then remove the lens by carefully prying on the edge of the lens with the flathead screwdriver.

  2. Disconnect the bulb by pulling it out.

    Overhead lights/Front map lights

     

     

    Rear map lights

     

     

    Vanity mirror lights (Some Models)

  3. Install the new bulb in the reverse order of the removal procedure.

Boot light (Saloon)

(LED type)

The LED bulb cannot be replaced as a single unit because it is an integrated unit.

The LED bulb has to be replaced with the unit. We recommend an Authorised Mazda Repairer when the replacement is necessary.

(Bulb type)

  1. Press both sides of the lens cap to remove it.

  2. Disconnect the bulb by pulling it out.

     

  3. Install the new bulb in the reverse order of the removal procedure.

Luggage compartment light (Wagon)

(LED type)

The LED bulb cannot be replaced as a single unit because it is an integrated unit.

The LED bulb has to be replaced with the unit. We recommend an Authorised Mazda Repairer when the replacement is necessary.

(Bulb type)

  1. Wrap a small flathead screwdriver with a soft cloth to prevent damage to the lens and remove the lens unit by carefully prying on the edge of the lens unit with the flathead screwdriver.

     

  2. Disconnect the electrical connector from the bulb by pressing the tab on the connector with your finger and pulling the connector.

     

     

    When replacing the bulb always disconnect the connector first. Otherwise, electric and electronic devices could be shorted.

    Close Caution
    View Caution

  3. Insert the flathead screwdriver into the gap between the lens and the lens unit, and then slide the screwdriver to detach the lens.

     

  4. Disconnect the bulb by pulling it out.

     

  5. Install the new bulb in the reverse order of the removal procedure.

Page top