Windows
Power Windows
The windows can be opened/closed by operating the power window switches.
Make sure the opening is clear before closing a window:
Closing a power window is dangerous. A person's hands, head, or even neck could be caught by the window and result in serious injury or even death. This warning applies especially to children.
Never allow children to play with power window switches:
Power window switches that are not locked with the power window lock switch would allow children to operate power windows unintentionally, which could result in serious injury if a child's hands, head or neck becomes caught by the window.
Make sure nothing blocks the window just before it reaches the fully closed position or while fully holding up the power window switch:
Blocking the power window just before it reaches the fully closed position or while fully holding up the power window switch is dangerous.
In this case, the jam-safe function cannot prevent the window from closing all the way. If fingers are caught, serious injuries could occur.
Opening/Closing Windows
The window opens while the switch is pressed and it closes while the switch is pulled up with the ignition switched ON. Do not open or close both windows at the same time.
The passenger window can be opened/closed when the power window lock switch on the driver's door is in the unlock position. Keep this switch in the locked position while children are in the vehicle.
-
A power window may no longer open/close if you continue to press the switch after opening/closing the power window. If the power window does not open/close, wait a moment and then operate the switch again.
-
The passenger windows may be opened or closed using the master control switches on the driver's door.
-
The power window can be operated for about 40 seconds after the ignition is switched from ON to ACC or off with all doors closed. If any door is opened, the power window will stop operating.
For engine-off operation of the power window, the switch must be held up firmly throughout window closure because the auto-closing function will be inoperable.
-
When the power window lock switch is in the locked position, the light on the passenger power window switch turns off. The light may be difficult to see depending on the surrounding brightness.
Auto-opening
To fully open the window automatically, press the switch completely down, then release. The window will fully open automatically.
To stop the window partway, pull up the switch and then release it.
-
The power window cannot be fully closed while the door is open.
-
Power window system initialization procedure
If the battery was disconnected during vehicle maintenance, or for other reasons (such as a switch continues to be operated after the window is open/closed), the window will not fully open automatically.
The power window auto function will only resume on the power window that has been reset.
-
Close the doors and the convertible top/roof.
-
Switch the ignition ON.
-
Make sure that the power window lock switch located on the driver's door is not depressed.
-
Press the switch and fully open the window.
-
Pull up the switch to fully close the window and continue holding the switch for about 2 seconds after the window fully closed.
-
Make sure that the power windows operate correctly using the door switches.
After the system has been re-initialized, passenger window can be fully opened automatically using the master control switches.
If the automatic power window operation does not operate normally while the doors or convertible top/retractable hardtop are opened/closed, reset it using the previous procedures.
-
