Audio Set [Type A (non-touchscreen)]

The clock can be set at any time when the ignition is switched to ACC or ON.

1. To adjust the time, press the clock button () for about 2 seconds until a beep is heard.

2. The clock's current time will flash.

   Time adjustment

   • To adjust the time, press the hour/minute set button (, ) while the clock's current time is flashing.

   • The hours advance while the hour set button () is pressed. The minutes advance while the minute set button () is pressed.

3. Press the clock button () again to start the clock.

1. Press the clock button () for about 2 seconds until a beep is heard.

2. Press the :00 button (1).

3. When the button is pressed, the time will be reset as follows:

   (Example)

   12:01―12:29→12:00

   12:30―12:59→1:00

 

---

• When the :00 button (1) is pressed, the seconds will start at “00”.

• Switching between 12 and 24-hour clock time:

  Press the menu button () several times until 12 and 24-hour clock time are displayed. Turn the audio control dial in either direction, select the desired clock setting while the preferred clock time is flashing.

Close Note

View Note

Press a band selector button () to turn the radio on.

The radio has the following tuning methods: Manual, Seek, Scan, Preset channel, and Auto memory tuning. The easiest way to tune stations is to set them on preset channels.

Manual tuning

Select the station by pressing the tuning button (, ) lightly.

Seek tuning

Automatic search for radio stations starts when the tuning button (, ) is pressed until a beep sound is heard. The search stops when a station is found.

 

---

If you continue to press and hold the button, the frequency will continue changing without stopping.

Close Note

View Note

Scan tuning

Press and hold the scan button () to automatically sample strong stations. Scanning stops at each station for about 5 seconds. To hold a station, press and hold the scan button () again during this interval.

Preset channel tuning

The 6 preset channels can be used to store 6 AM (Without Radio Data System (RDS)), MW/LW (With Radio Data System (RDS)) and 12 FM stations.

1. To set a channel first select AM (Without Radio Data System (RDS)), MW/LW (With Radio Data System (RDS)), FM1, or FM2. Tune to the desired station.

2. Press a channel preset button for about 2 seconds until a beep is heard. The preset channel number or station frequency will be displayed. The station is now held in the memory.

3. Repeat this operation for the other stations and bands you want to store. To tune one in the memory, select AM (Without Radio Data System (RDS)), MW/LW (With Radio Data System (RDS)), FM1, or FM2 and then press its channel preset button. The station frequency or the channel number will be displayed.

Auto memory tuning (Without Radio Data System (RDS))

This is especially useful when driving in an area where the local stations are not known.

Press and hold the auto memory button () for about 2 seconds until a beep is heard; the system will automatically scan and temporarily store up to 6 stations with the strongest frequencies in each selected band in that area.

After scanning is completed, the station with the strongest frequency will be tuned and its frequency displayed. Press and release the auto memory button () to recall stations from the auto-stored stations. One stored station will be selected each time and its frequency and channel number will be displayed.

 

---

If no stations can be tuned after scanning operations, “A” will be displayed.

Close Note

View Note