Instrument Cluster and Display
Instrument Cluster (Type B)
Speedometer
The speedometer indicates the speed of the vehicle.
Tachometer
The tachometer shows engine speed in thousands of revolutions per minute (rpm).
Do not run the engine with the tachometer needle in the RED ZONE.
This may cause severe engine damage.

When the tachometer needle enters the STRIPED ZONE, this indicates to the driver that the gears should be shifted before entering the RED ZONE.
Multi-information Display (Type B)

The multi-information display indicates the following information.
-
Odometer
-
Trip meter
-
Engine coolant temperature gauge
-
Fuel gauge
-
Outside temperature
-
Distance-to-empty
-
Average fuel economy
-
Current fuel economy
-
Maintenance Monitor
-
Blind Spot Monitoring (BSM) Display
-
Distance Recognition Support System (DRSS) Display
-
Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop & Go function) System Display
-
Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) Display
-
Vehicle Speed Alarm
-
Message Display
The screen content changes each time the INFO switch is pressed.

Odometer, Trip Meter and Trip Meter Selector
The odometer is constantly displayed on the screen when the ignition is switched ON, and the TRIP A or TRIP B screen can be displayed by operating the INFO switch.

Odometer
The odometer records the total distance the vehicle has been driven.
Trip meter
The driving distance for a specified interval is indicated. Two types (TRIP A, TRIP B) of interval distance and the average fuel economy for each can be measured.
For instance, trip meter A can record the distance from the point of origin, and trip meter B can record the distance from where the fuel tank is filled.
When trip meter A is selected, TRIP A will be displayed. When trip meter B is selected, TRIP B will be displayed.
The trip meter and average fuel economy can be reset by pressing the INFO switch for 1.5 seconds or more while in each mode.
-
Only the trip meters record tenths of kilometres (miles).
-
The trip record will be erased when:
-
The power supply is interrupted (blown fuse or the battery is disconnected).
-
The vehicle is driven over 9999.9 km (mile).
-
Engine Coolant Temperature Gauge
Displays the engine coolant temperature. The blue range of the gauge indicates that the engine coolant temperature is low, and the red range of the gauge indicates that the engine coolant temperature is high and overheating.

If the high engine coolant temperature warning light (red) flashes, there is a possibility of overheating. Drive slowly to reduce engine load until you can find a safe place to stop the vehicle and wait for the engine to cool down.
Refer to Overheating (Search).
-
The temperature unit (Centigrade/Fahrenheit) of the engine coolant gauge display changes in conjunction with the temperature unit of the outside temperature display.
Refer to Personalisation Features (Search).
Fuel Gauge
The fuel gauge shows approximately how much fuel is remaining in the tank when the ignition is switched ON. We recommend keeping the tank over 1/4 full.

If the fuel level is low, () and (
) turn an amber colour. Refuel as soon as possible.
If inconsistency in engine performance or stalling occurs due to low fuel level conditions, refuel the vehicle as soon as possible and add at least 10 L (2.7 US gal, 2.2 Imp gal) of fuel.
Refer to Taking Action (Search).
-
After refuelling, it may require some time for the indicator to stabilize. In addition, the indicator may deviate while driving on a slope or curve since the fuel moves in the tank.
-
The direction of the arrow (
) indicates that the fuel-filler flap is on the left side of the vehicle.
Instrument Panel Illumination
When the lights are turned on with the ignition switched ON, the brightness of the instrument panel illumination is dimmed. However, when the light sensor detects that the surrounding area is bright such as when the lights are turned on in the daytime, the instrument panel illumination does not dim.
-
When the ignition is switched ON in the early evening or at dusk, the instrument panel illumination is dimmed for several seconds until the light sensor detects the brightness of the surrounding area, however, the dimming may cancel after the brightness is detected.
-
When the lights are turned on, the lights-on indicator light in the instrument cluster turns on.
Refer to Headlights (Search).
The brightness of the instrument cluster and instrument panel illuminations can be adjusted by rotating the knob.
-
The brightness decreases by rotating the knob to the left. A beep sound will be heard when the knob has been rotated to the maximum dim position.
-
The brightness increases by rotating the knob to the right.

Function for cancelling illumination dimmer
The illumination dimmer can be cancelled by rotating the instrument panel illumination knob to the right until a beep sound is heard while the instrument cluster is dimmed with the ignition switched ON. If the instrument cluster's visibility is reduced due to glare from surrounding brightness, cancel the illumination dimmer.
-
The illumination dimmer can be cancelled by pressing the instrument panel illumination knob.
-
When the illumination dimmer is cancelled, the instrument cluster cannot be dimmed even if the lights are turned on.
-
When the illumination dimmer is cancelled, the screen in the centre display switches to constant display of the daytime screen.
Distance-to-empty
This displays the approximate distance you can travel on the remaining fuel based on the fuel economy.
The distance-to-empty will be calculated and displayed every second.

-
Even though the distance-to-empty display may indicate a sufficient amount of remaining driving distance before refuelling is required, refuel as soon as possible if the fuel level is very low or the low fuel warning light illuminates.
-
The display will not change unless you add more than approximately 9 L (2.3 US gal, 1.9 Imp gal) of fuel.
-
The distance-to-empty is the approximate remaining distance the vehicle can be driven until all the graduation marks in the fuel gauge indicating the remaining fuel supply disappear.
-
If there is no past fuel economy information such as after first purchasing your vehicle or the information is deleted when the battery leads are disconnected, the actual distance-to empty/range may differ from the amount indicated.
Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) Display
Displays the system status.

Refer to Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) (Search).
Message Display
A message such as the system operation status, a malfunction, or an abnormality is indicated.
Warning/indicator light in instrument cluster turns on/flashes or symbol is indicated on display at same time as message
Check the information regarding the warning/indicator light or indicated symbol.
Refer to If a Warning Indication/Warning Lights (Search).
Refer to If a Indication/Indicator Lights (Search).
Message only is indicated on display
Follow the instructions indicated on the display. For the display content, refer to the next page.
Refer to If a Message Indicated on Multi-information Display (Search).
Warning Indication/Warning Lights
These lights turn on or flash to notify the user of the system operation status or a system malfunction.
Signal |
Warning |
Page |
---|---|---|
![]() |
Brake System Warning Light*1 |
(Search) |
![]() |
ABS Warning Light*1 |
Electronic Brake Force Distribution System Warning (Search) |
ABS warning (Search) |
||
![]() |
Charging System Warning Indication/Warning Light*1 |
(Search) |
![]() |
Engine Oil Warning Light*1 |
(Search) |
![]() (Red) |
High Engine Coolant Temperature Warning Light*1 |
(Search) |
![]() |
Power Steering Malfunction Indication |
(Search) |
![]() |
Master Warning Indication |
(Search) |
![]() |
Electric Parking Brake (EPB) Warning Indication/Warning Light*1 |
(Search) |
![]() |
Check Engine Light*1 |
(Search) |
![]() (Amber) |
i-stop Warning Light*1 |
(Search) |
![]() |
i-ELOOP Warning Indication |
(Search) |
![]() |
Automatic Transaxle Warning Indication |
(Search) |
![]() |
AWD Warning Indication (Some Models) |
(Search) |
![]() |
Air Bag/Seat Belt Pretensioner System Warning Light*1 |
(Search) |
![]() |
Tyre Pressure Monitoring System Warning Light*1 |
Flashing (Search) |
Turns on (Search) |
||
![]() (Amber/White) |
KEY Warning Indication |
Amber (Search) |
White (Search) |
||
![]() (Amber) |
High Beam Control System (HBC) Warning Indication/Warning Light*1 (Some Models) |
(Search) |
Adaptive LED Headlights (ALH) Warning Indication/Warning Light*1 (Some Models) |
(Search) | |
![]() |
Blind Spot Monitoring (BSM) Warning Indication |
(Search) |
![]() (Amber) |
Driver Attention Alert (DAA) Warning Indication |
(Search) |
![]() (Amber) |
Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop & Go function) Warning Indication |
(Search) |
![]() |
Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) Warning Indication |
(Search) |
![]() |
LED Headlight Warning Light*1 |
(Search) |
![]() |
Smart Brake Support/Smart City Brake Support (SBS/SCBS) Warning Indication |
(Search) |
![]() |
Low Fuel Warning Indication |
(Search) |
![]() |
Engine Oil Level Warning Light*1 |
(Search) |
![]() |
Seat Belt Warning Light (Front seat) |
(Search) |
![]() (Red) |
Seat Belt Warning Light (Rear seat) |
(Search) |
![]() |
Door-Ajar Warning Indication |
(Search) |
![]() |
Liftgate-Ajar Warning Indication |
(Search) |
-
The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or when the engine is started. If the light does not turn on or remains turned on, have the vehicle inspected at an expert repairer (we recommend an Authorised Mazda Repairer).