Mazda ERA-GLONASS

Mazda ERA-GLONASS (Some Models)

Indicator Light/Beep Sound

Indicator Light/Beep Sound

The indicator light turns on/flashes and beep sounds are activated to notify the driver of the system operation status or if there is a problem with the system.

Status	Indicator light			Beep sound status	On/flashing conditions
Status	Green	Red	Flash interval	Beep sound status	On/flashing conditions
Diagnosis	Turns on	Turns on	―	―	When the ignition is switched ON, it turns on and then turns off after a few seconds. A manual emergency call is not possible during diagnosis. Close Note View Note
Normal	Turns off	Turns off	―	―	The system is operating normally.
Malfunction	Turns off	Turns on	―	3 beeps (Slow intermittent sound)	A system malfunction is detected. The remaining power of the built-in battery is low. If the indicator light (red) remains on constantly, the system will not operate normally. Have the vehicle inspected at an Authorised Mazda Repairer as soon as possible. Close Caution View Caution
Call being made with call centre	Flashes	Turns off	Slow (0.5 second intervals)	The beep does not sound, but the ringback tone can be heard.	An emergency call is being made by the Mazda ERA-GLONASS.
Vehicle information is being transmitted	Flashes	Turns off	Somewhat quick (0.3 second intervals)	Continuous intermittent sound	Vehicle information is being transmitted to the call centre.
Start of voice call	Turns on	Turns off	―	1 beep	During a voice call with the call centre.
During voice call	Turns on	Turns off	―	―	During a voice call with the call centre.
Connection failure	Flashes	Turns on	Quick (0.15 second intervals)	3 beeps (Fast intermittent sound)	When an emergency call fails to connect.

Page top