Towing

Follow these instructions to make your towing as safe and efficient as possible.

• Use only a Mazda-approved tow bar.

• Never exceed recommended load limits and always refer to the identification plate affixed to the tow bar.

• Before towing, inflate all tyres to the maximum recommended pressures.

  You'll find these specifications on the edge of the driver's door.

• When on a hill or towing with heavy loads, always use a lower gear. This helps maintain speed. It also prevents engine and transaxle overloading when going up hills and reduces the need for braking when going down hills.

• Always allow a greater stopping distance than normal to prevent excessive braking, and avoid sudden stops that could cause loss of control.

• Frequently inspect oil and fluid levels.

• Because of the extra stress on your Mazda from towing, more frequent maintenance than usual is necessary.

• Your Mazda's behaviour changes while towing. Get accustomed to these changes over a short and safe trial distance before starting a long trip.

• Headlights may need re-aiming after a trailer has been attached, especially if a load equalizing hitch is not used.

• Due to the additional stress on the engine cooling system when towing, the airflow to the radiator must not be restricted in any way.

• Make sure the towed vehicle complies with all local regulations, especially in regard to lighting, mirrors, and safety chains. The tow bar should not obscure the rear number plate.

• Whenever you remove the tow bar, seal all mounting holes in the underbody to prevent the entry of exhaust fumes, dust, and water.

• Avoid parking on an incline with a trailer. If this must be done, follow these instructions.

Parking on an Incline

1. Set the parking brake and the brakes.

2. Have someone block the wheels of the vehicle and trailer while you apply the brakes.

3. After the wheels are blocked, release the parking brake and the brakes slowly, allowing the blocks to bear the load.

4. Set the parking brake firmly.

5. Put the selector lever in P.

Starting on an Incline

1. Start the engine (Search).

2. Release the parking brake and slowly pull away a short distance from the wheel blocks.

3. Stop on the nearest level ground, set the parking brake, and pick up the wheel blocks.